I have BIAS AMP PRO, BIAS AMP 2 LE and BIAS FX PRO. Here's four examples of why I hate Positive Grid. There's no way, in Command Center, to have a single FS send more than one PC#. You can also set the Footswitches to send SPECIFIC PC#s or, if the BIAS HEAD allows it, whatever CC# (Control Change) it needs for Preset Previous/Next. When you load a Preset in HXFX, you can have each Snapshot set to send a different PC#, thus changing the Preset on the BIAS HEAD. When you load a Preset or change Snapshots within a Preset, the Instant Commands (lightning bolts) are sent to the external device (BIAS HEAD). If You have a link to the BIAS HEAD Manual (I'm not sure it exists) or the BIAS AMP SW Manual (I had a link, but it no longer works), I might be able to help you more, but otherwise all I can do is tell you how MIDI and Command Center work with PC#s.įor starters, you're mis-using the term BANK. Years after I decided that I hate Positive Grid, they still have one of the world's worst web sites. IIRC, when using BIAS SW, you do this by assigning a Program Change Number (PC#) to the Preset.Īgain IIRC, the BIAS HEAD is configured using the BIAS AMP SW. What you're actually changing is the BIAS PRESET. write to me like you're explaining it to an idiot.Īs I understand the way the BIAS Head works, there's only one "Channel" in the traditional sense. keep in mind if you answer I still don't really understand how the snapshots work ect. Like I said I'm super new, I've had this peddle 2 hours now just trying to program this simple (or I would think it would be simple) thing. I'm new to this and all I can figure is I have to waste to switches instead of just having an on and off effect on one. Ive managed to program a lighting bolt of instant whatever you're supposed to call it, to automatically go to one channel when I enter a bank, and I programmed a foot switch to change the channel, but once I click the foot switch a second time, it doesn't revert to the original channel. I want to program a bank to have a switch that sends a PC signal to the amp head to change to one channel when pressed, and go to another channel when not pressed.Īnd I can t seem to figure out how to do this. currently I have it hooked up into the fx loop of my Bias head
Here's my situation, I have an HX effects not the full helix in case that matters. I'm really having difficulty with figuring out exactly what I'm doing with this thing